Model | 42 |
|
|
Panel Installation
If your customer has ordered either a framed or overlay model, you will be installing a door panel to give the unit the custom
IMPORTANT NOTE: For overlay models, there are two design applications, overlay and flush inset. Be sure to use the correct panel sizes for your application.
If your customer has chosen the stainless steel design, the unit has been shipped complete with a finished stainless steel look. It will not be necessary to install a door panel or handle hardware. In your final preparation for stainless steel units, use a stainless steel cleaner to remove any marks. Abrasive cleaners should not be used, as they may scratch the surface.
IMPORTANT NOTE: Side panels, if used, will need to be installed before the unit is placed in its final position. Refer to page 53.
Complete the Installation
ANCHORING
After door and side panels have been installed, the unit has been leveled and door adjustment completed, anchor the wine storage unit to the opening. This will assure a proper fit and a secure installation.
IMPORTANT NOTE: Be sure to level and square the unit before anchoring it.
To anchor the top of the unit to cabinetry, open the grille, and install the screws provided through the grille frame into the cabinetry. There are several hole locations provided. Check for proper door clearance by fully opening the door. Refer to the illustration below.
To anchor the bottom of the unit, drive a screw through the side hole inside the roller base assembly. There is one on each side. The screw will need to go in at an angle in order to attach properly. Refer to the illustration below. Additional material may be needed behind the cleat to ensure sufficient anchoring.
If the screws provided are not suitable for your application, you must provide adequate screws.
ANCHORING
SCREWS
ANCHORING
SCREW
Top anchoring. | Bottom anchoring. |
