Sub-Zero 427G, 427RG, 424FSG Model WS-30 Installation, Anti-Tip Bracket Installation, subzero.com

Model WS-30 Installation 37

Anti-Tip Bracket Installation

To prevent the unit from tipping forward and provide a stable installation, the unit must be secured in place with the anti-tip brackets provided.

IMPORTANT NOTE: Placement of the anti-tip brackets is critical to a stable installation. Failure to properly position the anti-tip brackets will prevent them from engaging the unit.

The two anti-tip brackets must be installed exactly 24"

(610)from the front of the rough opening to the back of the brackets and a minimum of 4" (102) from the sides of the rough opening. This depth will increase to 263/16" (665) for a flush inset installation based on 3/4" (19) deep decorative panels. Proper placement will ensure that the anti-tip brackets engage the anti-tip bar at the back of the unit.

To properly secure the anti-tip brackets for a stable instal- lation, use all anti-tip bracket hardware as instructed for wood or concrete floors.

Anti-Tip Bracket Hardware

2 Anti-tip brackets

12 #12 x 21/2" PH pan HD zinc screws

43/8"–16 x 33/4" wedge anchors

12#12 flat washers

4#8–18 x 11/4" PH truss HD screws

4Nylon zip-it wall anchors

subzero.com

IMPORTANT NOTE: For either wood or concrete floor applications, if the #12 x 21/2" screws do not hit a wall stud or the wall plate in any of the back holes of the brackets, use the provided #8–18 x 11/4" PH truss HD screws and #12 flat washers with the nylon zip-it wall anchors.

IMPORTANT NOTE: In some installations the subflooring or finished floor may necessitate angling the screws used to fasten the anti-tip brackets to the back wall.

Make sure there are no electrical wires or plumbing in the area which the screws could penetrate.