Sub-Zero 427RG, 427G, 424FSG, 424G Model WS-30 Installation, Flush Inset Panels-Dual Installation

Model WS-30 Installation 52

Flush Inset Panels—Dual Installation

When installing two models WS-30 or a model WS-30 and built-in unit side by side in a flush inset application, you must decrease the width of the decorative flush inset panels by 1/2" (13). Adjustments to the panel offsets will also need to be made. These adjustments are needed to achieve a proper fit and to ensure the panels do not collide when closing. Panel dimensions in the chart below have been adjusted to reflect the decrease in panel dimensions.

IMPORTANT NOTE: If a filler strip is not used, dual instal- lations can only be accomplished using two units with

TOP VIEW
DOOR / DRAWER / GRILLE
BACKER	CABINETRY
SPACER
FLUSH INSET PANEL
5/16" (8)	1/2"
	(13)
	5/8"
	(16)

	TOP VIEW
	DUAL
	TRIM
DOOR	DOOR
5/16" (8)
1/8" (3)
	1/4" (6)
	REVEAL

opposite hinges.

Illus. A Illus. B

Illustrations A–E provide panel offsets and reveals for model WS-30 in a flush inset application. Refer to the chart below for reference to the illustrations. All reveals are 1/2" (13) unless otherwise specified.

For additional information on panel reveals, visit the speci- fication library section of our website, subzerotrade.com.

Do not exceed the flush inset decorative panel dimen- sions. Exceeding dimensions could cause damage to the panels and the Sub-Zero unit.

CABINETRY
	1/2"(13)
	1/8"
GRILLE	5/16" (3)
	(8)
	SIDE VIEW

GRILLE	5/16"
	(8) 5/32"
	(4)
	1/2"(13)
DOOR	3/32"
	5/16" (2)
	(8)
	SIDE VIEW

Panel Offsets	Illus.
WS-30
Doors (hinge) / Grille Sides	A
Doors (handle) Sides	B
Grille Top	C
Grille Bottom / Door Top	D
Door Bottom	E

Illus. C Illus. D

DOOR /
DRAWER
	5/16"
	(8)
	3/32"
SIDE VIEW	(2)

Illus. E