Models 427G and 427RG Installation | 19 |
Electrical Requirements
HOME ALARM SYSTEM
If a home alarm system is to be used, refer to wiring connections on page 24. In addition to operating power, the installer may also be required to supply a home automation system lead to the unit. This is for a low- voltage,
Three 1/4" female spade connectors are located in the compressor compartment and are accessible behind the kickplate/grille on models 427G and 427R. A minimum of 36" (914) of lead wire should be provided for each contact, exiting the back wall near the electrical outlet.
subzero.com
To prevent the unit from tipping forward and provide a stable installation, the unit must be secured in place with the
An
If you are installing the model 427G or 427RG in a space deeper than 24" (610), the
IMPORTANT NOTE: In some installations the subflooring or finished floor may require angling the wood screws used to fasten the
Make sure there are no electrical wires or plumbing in the area which the screws could penetrate.