Models 424G and 424FSG Installation | 9 |
MODEL 424FSG—WOOD FLOORS
Use the four #12 x 21/2" wood screws and the four 1/4" flat washers provided. Drill pilot holes 3/16" (5) diameter maximum, and be sure that the screws penetrate through the flooring material and into the wall plate a minimum of 3/4" (19). Be sure that the screws hold tight. Refer to the illustration below.
MODEL 424FSG—CONCRETE FLOORS
Use the two 3/8" x 33/4" concrete wedge anchors, two #12 x 21/2" wood screws and two 1/4" flat washers provided. Be sure that the anchors and screws hold tight. Refer to the illustration below.
IMPORTANT NOTE: In some installations the subflooring or finished floor may require angling the wood screws used to fasten the
Make sure that there are no electrical wires in the area which the screws could penetrate.
subzero.com
INSTALL CONCRETE WEDGE ANCHORS:
1)Drill a 3/8" (10) diameter hole any depth exceeding the minimum embedment. Clean the hole or continue drilling additional depth to accommodate drill fines. Use a carbide drill bit manufactured within ANSI
2)Assemble the washer and nut flush with the end of anchor to protect threads. Drive the anchor through the material to be fastened until the washer is flush with the surface material.
3)Expand the anchor by tightening the nut
Always wear safety glasses and use other necessary protective devices or apparel when installing or working with anchors.
Anchors are not recommended for use in lightweight masonry material such as block or brick, or for use in new concrete which has not had sufficient time to cure. The use of core drills is not recommended to drill holes for the anchors.
| 24" | |
| (610) | |
C |
| |
L | 123/16" | |
123/16" | ||
(310) | ||
(310) |
| |
FINISHED FLOORING | ||
UNDERLAYMENT |
| 24" | |
| (610) | |
C |
| |
L | 123/16" | |
123/16" | ||
(310) | ||
(310) |
| |
FINISHED FLOORING | ||
UNDERLAYMENT |
WALL PLATE | WALL PLATE |
| |
SUBFLOORING | SUBFLOORING |
|
| 11/2" | CONCRETE | |
WOOD FLOOR | min | ||
(38) | FLOOR | ||
|
Wood floors. | Concrete floors. |