Model | 40 |
|
|
Position the Unit
Before moving model
Use an appliance dolly to move the unit near the rough opening. Model
IMPORTANT NOTE: If for any reason the unit has been laid on its back or side, you must allow the unit to stand upright for a minimum of 24 hours before connecting power.
IMPORTANT NOTE: If used, side panels will need to be installed before the unit is placed in its final position. Refer to page 53.
The rear levelers must be in their lowest position in order to roll the unit back into the rough opening. Leveling cannot be completed until the unit is in position.
Shut off power to the electrical outlet. Plug the power cord into the grounded outlet and roll the unit into position. Make sure the
Level the Unit
Once the unit is in position, extend the front leveling legs down by turning the legs clockwise to adjust the height. The rear height adjustment can be made from the front of the base. Use a 3/8" socket to adjust the rear rollers. Turn the 3/8" hex bolt clockwise to raise the unit or counter- clockwise to lower it. Refer to the illustration below for location of the rear roller base adjustment.
When the unit is properly leveled, door adjustments are less likely to be necessary.
IMPORTANT NOTE: Be sure to reference leveling of the unit to the floor and not surrounding cabinetry. This could affect the operation of the unit, such as door closing.
To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor.
FRONT
LEVELING LEG
REAR
ADJUSTMENT