Sub-Zero 427G, 427RG, 424FSG, 424G manual Model WS-30 Installation, Side Panels

Model WS-30 Installation 53

Side Panels

IMPORTANT NOTE: Side panels will need to be installed before the unit is placed in its final position.

When installing a model WS-30 with a custom side panel, an accessory kit is required. Stainless steel and white enamel side panels are available through your authorized Sub-Zero dealer. Refer to instructions included with the side panel kit when installing these side panels. For local dealer information, visit the find a showroom section of our website, subzero.com.

IMPORTANT NOTE: The use of side panels may change the width of your rough opening.

subzero.com

CUSTOM SIDE PANEL INSTALLATION

The custom side panel will need to be a minimum of 24"

(610)deep and 1/2" (13) thick. Refer to the custom side panel dimensions illustration for additional specifications. Routing will be necessary for the side panel to fit flush against the side of the unit. Refer also to the routing detail illustration.

IMPORTANT NOTE: The overall height on the side panel will vary with the height of the grille being used. Make sure you know your finished height before cutting any panels.

24" (610)

ROUT TO 1/8" (3)

17/8"(48)

1" (25)

FRONT

OF SIDE

PANEL

84"

(2134)

1" (25)
	17/8" (48)
1/8" (3)
1/2" (13)
MAIN	SIDE PANEL
FRAME	ROUTING

Routing detail.

4" (102)

OPTIONAL		25/8"
TOE KICK
CUT-OUT	(67)

Custom side panel dimensions.