Maytag RAX3300CXX, RAX3600CXX installation instructions £Z. LOV,ER Right COR.ER

24[3_dwardsStree[,SE Cleveland,Tennessee373t! [e] 423472-3333 Fax:a23,:78-67!0

15, Position 1/4" U-shaped panel channel so the end is against the lower H--trim and with soft nose against

_e right side of the handle. Apply pressure to the "hard side" of the panel channel to slightly compress the soft nose against the handle. Then press down firmly to insure proper tape bonding,

F,._,_,_£Z. LOV,ER RIGHT COR.'_ER.

-PAN_ C.HA_EL

/It. TIUI_

P

U._ I_, .

CHRO_ F_ _'_" C_ _ H.TetU _£C_

IMPORTANT: Once adhesive bonds to the door panel, it cannot be removed. Make sure you align panel channel properly as you work towards the top of the door.

16.As you work up toward the top of the door, pull tape backing to expose adhesive to door panel Press

down firmly to insure bond.

17, Peel back approximately three to four inches of the protective backing from each end of the foam tape on the refrigerator top and bottom perimeter trim. Crease to form pull tabs.

18.Set custom 1/4" thick panel into lower H-trim and U-shaped panel channel. (Custom 1/4" decorator panel sizes are found on the last pace of these instructions.

. la, ti-_-IAD[DP_rEL_NI;£L