6CYCLE SIGNAL
Use this button to turn the signal indicating the end of a drying cycle on or off.
Control Lock
If the dryer is running:
Press and hold the Cycle Signal button for 3 seconds to lock the controls of the dryer and avoid an accidental change in cycle options or settings during a drying cycle. Press and hold again for 3 seconds to unlock.
To enable the Control Lock feature if the dryer is off, it is not necessary to press POWER before activating the Control Lock feature.
CYCLE STATUS INDICATORS
Steam model shown
The Cycle Status Indicators show the progress of a cycle.
Sensing
The Sensing indicator will light during Sensor Cycles to indicate that the moisture sensor on the dryer is operating. This indicator will not light during Timed Cycles or options such as Wrinkle Prevent™.
Wet
The load is still wet and/or the cycle just started.
In the Custom Refresh or the Auto Refresh Steam Cycles (on some models), the Wet indicator comes on after the water has been sprayed into the drum,
Damp
This indicator is used with Sensor cycles to show that the load is partially dried and items that you may wish to hang up or iron while still damp may removed.
Cool Down
The dryer has finished drying with heat, and is now tumbling the load without heat to cool it down and reduce wrinkling.
Done
This will indicate that the selected cycle has ended and the load may be removed from the dryer. If the Wrinkle Prevent option has been selected, the dryer may continue to tumble the load, even if the Done indicator is lit.
Wrinkle Prevent™
This indicator will light if the Wrinkle Prevent option has been selected and is running. The dryer will continue to tumble the load for up to 90 minutes after the cycle has ended.
Steam (on some models)
This indicator will light when the Steam function is active. NOTE: Steam is not available on all models or on all cycles.
Controls Locked
This indicator will light when the controls are locked. Press and hold the Cycle Signal button for 3 seconds to unlock.
7
