AMPLIFIER APPLICATIONS
PAB 2100 2-Channel Amplifier
Full range stereo
This is the most basic application for the Premium Series 2 channel amplifiers.
1.Interconnect cable checklist:
Connect the LINE INPUTS to the Radio/CD with good quality RCA cables.
2.Crossover Switch:
The
3.Crossover frequency control checklist: N/A for full range operation.
4.Line Level:
Refer to the section “Setting up systems after installation for best performance”
5.Bass Remote Module:
Plug in the Bass Remote Module to the amplifier “REMOTE” jack.
Full range mono
This application illustrates the basic mono bridging method for all MB QUART amplifiers.
Interconnect cable checklist:
A MONO signal source is required, such as would be available from the mono sub bass output of an active crossover, whether stand alo- ne, or built into a head unit or equalizer. Important: Do not be temp- ted to connect the hot, or positive outputs, from any source together to obtain a mono signal, as this could very well damage the output stage of that source.
It is necessary to feed the SAME signal to both left and right inputs via a
NOTE:
Minimum final loudspeaker impedances:
4 & 2 Ohms stereo mode or
This amplifier will not do 1 Ohm stereo or 2/1 Ohm mono
operation.
Switch setting checklist:
The AMPLIFIER
Crossover frequency control setting checklist:
N/A for full range operation.
TIP: If you are using the mono sub bass output of an active crossover, there is nothing wrong with switching in the low pass filter in these amplifiers for a steeper low pass rolloff.
Minimum final loudspeaker impedance: 4 ohm mono
6
