2 | MOUNTING COVER ASSEMBLY TO |
| SUPPORT ASSEMBLY (See Fig. 2) |
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting cover assembly to tractor.
1.Position cover assembly on ground behind tractor.
2.Lift and rotate cover to align cover brackets with support assembly tubes.
3.Slide cover assembly down onto the support tubes.
3 CONTAINER ASSEMBLY (See Fig. 3)
1.Place bottom half inside of top half, as shown.
2.Place one foot inside bottom half and lift top half to meet bottom half.
3.Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN IN INSET.
4. Repeat for other containers.
COVER ASSEMBLY
SUPPORT |
ASSEMBLY |
03024 |
FIG. 2
CONTAINER
BOTTOM HALF
89 020
CONTAINER
TOP HALF
| 02739 | PRESS TOGETHER |
|
| |
CONTAINER |
| TO FORM SEAL |
| WHILE LIFTING | |
TOP HALF |
| |
| TOP HALF | |
|
|
CONTAINER
BOTTOM
HALF
LOCKING
TAB
FIG. 3
ASSEMBLY CHECK: Squeeze sides of lower half of con- tainer and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.
02097
6
