Troubleshooting table
| The engine | The engine stutters | The machine |
| does not | starts but does | |
| or loses power | ||
| start | not cut properly | |
|
| ||
|
|
|
|
Make sure the STOP switch is on I. | • |
|
|
Make sure that the fuel tank is at least 25% | • | • |
|
full. |
| ||
Make sure the air filter is clean. | • | • |
|
|
| ||
Remove the sparkplug, dry and clean it, | • | • |
|
then return it to its place. If necessary, |
| ||
replace it. |
| ||
|
|
|
|
Check and if necessary adjust the screws |
| • |
|
on the carburetor |
|
| |
Change the fuel filter. Contact your supplier. |
| • |
|
|
|
| |
Follow the correct procedure for assembly |
|
| • |
of the cutting accessories. |
|
| |
Make sure the metal accessories are sharp, |
|
| • |
and contact your supplier if necessary. |
|
|
The engine continues to have problems: contact your authorized supplier.
Environmental information
This section contains information useful for main- taining the characteristics of
1. DESIGN
In the design stage, care was taken to develop an engine with reduced consumption and low emis- sions of noise and pollutant exhaust fumes.
2. USE OF MACHINE
The operations of filling the tank with the fuel mix- ture should be carried out in such a way as to avoid spilling fuel and contaminating the soil and environment.
3. PERIODS OF PROLONGED DISUSE
Always empty the fuel tank with the same precau- tions used in filling it.
4. DISPOSAL
Do not dispose inappropriately of the machine when it is no longer usable. Deliver it to an authorized organization for proper disposal in compliance with the regulations in force.
ENGLISH - 8