Using Your Canister Steam System
FILLING BOILER
1.Place Canister Steam System on a flat, level surface.
2.Make sure illuminated On/Off Switch is turned to “Off” and grounded power cord is unplugged from electrical outlet.
!If unit has been in use, always use the following safety precautions before removing the Boiler cap to add water:
•Allow unit to cool for 20 minutes or until pressure gauge is at zero.
•Press and hold Steam Trigger to release ALL remaining steam.
WARNING: Failure to follow these precautions may result in burns from escaping steam when the Boiler Cap is removed.
3.Cautiously unscrew and remove Boiler Cap.
WARNING: Water may be hot.
4.Drain any water remaining inside Boiler.
NOTE: The Boiler should be emptied after each use – this will help minimize mineral
5.Using the Fill Cup, fill the unit with 48 oz (1,420 ml) of water.
NOTE: In order to significantly reduce mineral
WARNING: Caution should always be used when pouring water into the Boiler. Do not look directly down into fill hole when filling. Keep your free hand and any children or pets at a safe distance.
6.Replace Boiler Cap, ensuring that it is screwed on tightly to prevent hot steam from escaping and causing injury.
ENGLISH 13