Reset of Microprocessors
In the event that the controls of the C500 stop functioning press and hold the STANDBY/ON
Figure 85
Note: The above condition is usually caused by either interruptions in AC power and/or major changes in voltage.
Configuration Change
When a change is made to a C500 System (Controller and Preamplifier) by changing the current Preamplifier type (C500P or C500T) , the Front Panel Alphanumeric Display will indicate “CONFIG CHANGE” and the LED indicators above the SETUP and REC MONITOR
and 87. If there is not to be any
changes to the C500 System, but rather reconnecting a
Preamplifier that was previ- ously connected to the C500 Controller perform the follow- ing:
Figure 87
1.Remove the AC Power Cord from the Rear Panel of the C500 Controller.
2.Reconnect the previously connected Preamplifier.
3.Reattach the AC Power Cord.
4.The C500 System will automatically reset itself and will retain any changes that where previously made in the SETUP Mode.
If the change to the C500 System is a result of changing Preamplifier Types (C500P or C500T) then perform the fol- lowing steps:
1.Remove the AC Power Cord from the Rear Panel of C500 Controller.
2.Connected the Preamplifier(s) to the C500 Controller.
3.Reteach the AC Power Cord.
4.Press and hold the SETUP and REC MONITOR Front Panel
Figure 88
Figure 89
Figure 90
Figure 91
5.For any changes from the default settings that are de- sired go to page 16 SETUP to perform them at this time.
32
