Installation, con’t
2.Attach either the flush mount or angle mount bracket to the rear of the Loudspeaker using the two screws (just removed in the previous step), being sure to orient the bracket as illustrated
in figures 15 and 16. |
|
|
3. Determine the Loudspeaker | Remove | |
Mounting Location on the wall, | Screws | |
making sure the Mounting |
| |
Bracket will be anchored to a |
| |
stud located inside the wall. | Figure 14 | |
Note: Use |
|
|
extreme |
|
|
caution to |
|
|
avoid any |
|
|
existing |
|
|
electrical |
|
|
wiring, |
|
|
plumbing, etc., |
|
|
located inside |
|
|
the wall. | Figure 15 |
|
4.Refer to figures 17
and 18 to install the appropriate Wall Bracket on the wall (orient the bracket as illustrated) using the sup- plied Mounting Screws. If the Flush
Mount Bracket is used, attach the | Figure 16 |
|
Figure 17 | Figure 18 |
two cone shaped rubber bumpers to the rear of the Loudspeaker, near the bottom.
Note: If the wall covering material and/or thickness is different from the illustration, the two supplied Mounting Screws need to be replaced with screws of the appropriate type and length.
5.Orient the Loudspeaker with the rounded end at the Top, carefully line up the Loudspeaker Bracket with the Wall Bracket and lower the Loudspeaker. If the angle mount is used, install the Locking Screw to se- cure the Loudspeaker at the desired angle.
6.Align the Grille fasteners to the Loudspeaker Grom- mets (two on each side). Carefully push down to secure the Grille to the Loudspeaker.
How to Mount the XLS340 Loudspeaker On the Wall
The supplied On Wall Mounting Brackets allow for two different mounting positions of the XLS340 Loudspeaker relative to the wall. The first position is flush mount, with the Loudspeaker close to and parallel with the wall. The second position is angle mount, which places the Loud- speaker further away from the wall and allows for horizon- tal rotation of ± 30 Degrees. Refer to figure 19.
1. Using the supplied Allen Wrench, remove four screws
Angled Wall Mounting | Flush Wall Mounting | |
Hardware | Hardware | |
Wall | Loudspeaker | |
Bracket | ||
Bracket | ||
| ||
Locking | Wall | |
Screw | Bracket | |
Loudspeaker |
| |
Bracket | Wall Mounting | |
| Screws |
Figure 19
from the rear of the XLS340 Loudspeaker System. Re- fer to figure 20.
2.Attach either the flush mount or angle mount brackets to the rear of the Loudspeaker using the four screws (just removed in the previous step), being sure to orient the bracket as illustrated in figures 21 and 22.
3.Determine the Loudspeaker Mounting Location on the wall, making sure the Mounting Brackets will be an- chored to a stud located inside the wall.
14
