Installation, con’t
7.Attach the four rubber bumpers to the bottom long edge of the XCS350 Loudspeaker System. Refer to fig- ure 8.
8.Loosen, but do not remove, the three screws securing the Stabilizer Bar to the back of the XCS350. Refer to
figure 9.
Stabilizer Bar Screws
Stabilizer Bar
Figure 9
9.Reposition the Stabilizer Bar even with the previously applied rubber bumpers on the side edge of the XCS350 enclosure. Refer to figure 10.
Figure 10
10.Tighten the three screws securing the Stabilizer Bar to keep it in place, but not enough to prevent changing the angle of the XCS350 in the following steps.
11.The vertical angle of the XCS350 may be changed ±5.5 degrees from perpendicular, allowing the sound to be directed upwards or downwards to accommodate the seating arrangement in the room. Refer to figure 11. This can be accom-
plished by tempo- rarily loosening the three screws and moving the Stabilizer Bar up or down. When the desired angle is achieved, tighten the three screws.
12.Rotate the XCS350 Loudspeaker over with the front facing up, being careful not to damage the Loud- speaker Drivers. Refer to figure 12.
Grommets | Fasteners | Grille |
Figure 12
13.Locate the Loudspeaker Grille and align the Grille fas- teners to the Loudspeaker Grommets (four on each side). Carefully push down to secure the Grille to the Loudspeaker.
14.Proceed to “Locating the Loudspeaker System” on page 18.
How to Mount the XLS320 Loudspeaker On the Wall The supplied On Wall Mounting Brackets allow for two different mounting positions of the XLS320 Loudspeaker relative to the wall. The first position is flush mount, with the Loudspeaker close to and parallel with the wall. The second position is angle mount, which places the Loud- speaker further away from the wall and allows for horizon- tal rotation of ± 30 Degrees. Refer to figure 13.
Angled Wall Mounting | Flush Wall Mounting | |
Hardware | Hardware | |
Wall | Loudspeaker | |
Bracket | ||
Bracket | ||
| ||
Locking | Wall | |
Screw | Bracket | |
Loudspeaker |
| |
Bracket | Wall Mounting | |
| Screws |
Figure 13
1.Using the supplied Allen Wrench, remove two screws from the rear of the XLS320 Loudspeaker System lo- cated below the recessed connection plate. Refer to fig- ure 14 on the next page.
13
