How to Connect the XLS320 Loudspeakers
Connection for use with a High Power
Amplifier (optional setting)
Preparing Hookup Cables | 3. Tighten all of the Loudspeaker and Amplifier Binding | |
The McIntosh Loudspeaker Systems utilize binding posts | Posts. | |
for speaker wire connections. Prepare the Loudspeaker | Note: The Low Frequency Response of a XLS320 | |
Hookup Cables that attach to the Power Amplifier Output | Loudspeaker may be extended with the addition of | |
Terminals: | a Powered Subwoofer like the McIntosh XLS112 to | |
Bare wire cable ends: | the Music/Home Theater System. | |
4. Connect the remaining Loudspeaker(s) and Amplifier | ||
Carefully remove sufficient insulation from the cable | ||
Channel(s) in the same manner. | ||
ends, refer to figures 43, 44 and 45. If the cable is | ||
| ||
stranded, care- |
| |
fully twist the |
| |
strands to- |
| |
gether as |
| |
tightly as pos- | Connection plate | |
sible. | ||
Note: If desired, the twisted ends can be tinned with |
| |
solder to keep the strands together and/or attach a |
| |
spade lug. |
| |
Spade lug or prepared wire connection: |
| |
Insert the spade lug connector or prepared section of |
| |
the cable end into the terminal side access hole, and |
| |
tighten the | Jumper | |
terminal | ||
| ||
cap until |
| |
the cable |
| |
is firmly |
| |
clamped |
| |
into the terminal so the wires cannot slip out. Refer to |
| |
figures 46, 47 and 48. |
| |
Connections using a single Amplifier |
| |
1. Connect a Loudspeaker cable from the COMmon |
| |
(Negative) Binding Post of the appropriate Amplifier |
| |
Channel to the Loudspeaker HIGH POWER |
| |
NEGATIVE |
| |
2. Connect a Loudspeaker cable from the 8S | McIntosh Two Channel Power Amplifier | |
(OHM) or Positive (+) Binding Post of the same | ||
| ||
Amplifier Channel to the Loudspeaker HIGH |
| |
POWER POSITIVE (+) Binding Post. |
|
Note: The HIGH POWER and LOW POWER NEGATIVE
21