Installation, con’t
How to Mount the XCS350 Loudspeaker On the Wall The supplied On Wall Mounting Brackets allow for four different mounting positions of the XCS350 Loudspeaker relative to the wall, both vertical and horizontial. Two posi- tions are flush mount, with the Loudspeaker close to and parallel with the wall. The other positions are angle mount, which places the Loudspeaker further away from the wall and allows for rotation of ± 30 Degrees. Refer to figure 25.
Angled Wall Mounting | Flush Wall Mounting | |
Hardware | Hardware | |
Wall | Loudspeaker | |
Bracket | ||
Bracket | ||
| ||
Locking | Wall | |
Screw | ||
Bracket | ||
| ||
Loudspeaker | Wall Mounting Screws | |
| ||
Bracket |
| |
| Figure 25 |
1. Using the supplied Allen Wrench, remove the three |
screws securing the Stabilizer Bar to the back of the |
XCS350. Refer to figure 26. Replace the just removed |
center screw with a supplied one of the same type, but |
shorter length. Refer to figure 28. |
Note: Retain the three removed screws and Stabilizer Bar |
Location of
Mounting
Screws
Replace with
supplied
shorter screw
Location of
Mounting
Screws
Figure 28
bumpers to the tom.
Screws - A
Screws - B
Figure 29
3.Determine the Loudspeaker Mounting Location on the wall, making sure the Mounting Bracket will be anchored to a stud located inside the wall.
Note: Use extreme caution to avoid any existing electrical wiring, plumbing, etc., located inside the wall.
4.Refer to figures 31 thru 34 to in-
stall the appropriate Wall Bracket on the wall (orient the bracket as
illustrated) using the supplied Mounting Screws. If the Flush Mount Bracket is used, attach the two cone shaped rubber
rear of the Loudspeaker, near the bot-
for possible future use. |
Stabilizer Bar
Stabilizer Bar Screws
Figure 26
2.Attach either the flush mount or angle mount brackets to the rear of the Loudspeaker using the supplied screws. Refer to figures 27, 28 and 29 for the screw location. Also, be sure to orient the bracket as illus- trated in figure 30.
Note: If the wall covering material and/or thickness is different from the illustration, the two supplied Mounting Screws need to be replaced with screws of the appropriate type and length.
5.Orient the Loudspeaker to line up with the Wall Brack- ets and attach them together. If the angle mount is used, install the Lock-
ing Screw to secure the Loudspeaker at the desired angle.
Figure 30
XCS350 Screw Removal for Mounting
Mounting Type | Screw s - A | Screws - B |
Vertical Flush Mount | Remove | |
Vertical Angle Mount | Remove | |
Horizontal Flush Mount | Remove | |
Horizontal Angle Mount | Remove | |
| Figure 27 |
|
16
