Xantrex Technology Comprehensive Guide to Xantrex PROsine 2.0 Error Messages

		Error Messages
Table 6-3Error Messages
Error Message	Details	Action
Invert Hi Bat V	Inverter battery voltage greater than	Check for external charging sources and disable
	16V.	if necessary.
AC Out Overload	AC output overload.	Reduce the AC load so that even for short times,
		the AC output current does not exceed 26A.
Ext Comm Timeout	PROsine external communications	Check that the connections on the
	timeout	communications cable between the PROsine and
		the display panel are secure.
		Check whether the communications cable has
		been damaged.
		Check the proximity of the communications
		cable to DC and AC cables. If the cable crosses
		DC or AC cables, ensure that it does so at right
		angles.
Charge Lo Bat V	Battery voltage did not rise above 10V	Clear the error and restart the charging process.
	within 30 seconds of the charger	If battery V does not come to 10V after a few of
	starting. This may indicate a problem	charging cycles, have your battery tested.
	with the battery (e.g. a damaged
	battery), but will also occur if the
	battery was very dead at the start of the
	charge cycle.
SeriesComTimeout	Series communication timeout	Ensure that both PROsines have power.
		Ensure that the ON/OFF/REM switch for both
		units is ON (or REM if Remote Shutdown is
		being used).
		Ensure that both PROsines are configured
		correctly and are enabled.
RelayWeldDetect0	The internal transfer relay is unable to
	switch between shorepower and
RelayWeldDetect1
	inverter output. Charge/passthrough or	Call Xantrex.
RelayWeldDetect2	Invert modes may be unavailable.
AC Backfeed	You have applied an AC source	Check AC input and output wiring. The AC
	(shorepower) to the inverter output.	output wiring should not be connected to an AC
	This has been caused by improper	source at any time.
	wiring. This error can also be caused by
	a short circuit on the AC output wiring.

445-0089-01-01 6–7