Xantrex Technology PROsine 2.0 user manual Mounting the Display Panel, To mount the display panel

Installation

Step 8: Mounting the Display Panel

The communications cable supplied with the display panel is 70 feet long (21 meters). If you want to replace the cable with one that is longer or shorter, use a high quality, 6-wire telephone extension cable. You can install the panel up to 100 feet (30 meters) away from the PROsine.

Flush mounting the panel on a wall, bulkhead, or panel requires an opening that is approximately 4 inches x 4 inches (10cm x 10cm). About 1 1/4 inches (3cm) of free space is required within the wall to accommodate the depth of the panel. Be sure there is no wiring or other obstructions within the wall before you make an opening.

To mount the display panel:

1.Choose a location that is dry, out of direct sunlight, free from corrosive or explosive fumes, and otherwise appropriate for mounting an electronic device.

2.Tape the mounting template (in the PROsine package) to the mounting surface and mark the locations of the mounting holes and the area to be cut away.

3.Pilot-drill the mounting holes and cut out the hole in which the panel will be inserted.

4.Route the communications cable(s) inside the wall and through the opening.

5.Insert one of the cable’s connectors in either jack on the bottom of the panel.

6.Place the panel in the opening and secure it with appropriate fasteners.

7.Route the communications cable to the PROsine and insert the connector in the jack labelled DISPLAY.

3–20 445-0089-01-01