
Configuration
Auto Restart After
Error
|
| WARNING: Shock hazard |
|
| If Auto Restart is selected, AC voltage can reappear at the loads without notice after a |
|
| fault has occurred and cleared. |
|
|
|
|
| If you select Yes, the PROsine will attempt to restart (five attempts) after a fault |
|
| has occurred. |
|
| If you select No, the PROsine ceases operation when an error occurs. It then |
|
| requires that you manually restart the unit by going to the Configuration menu |
|
| and clearing the error. |
|
| Exception: If the PROsine shuts down in Invert mode because of low battery and |
|
| the charger is enabled and AC is then supplied to the PROsine, it will |
|
| automatically charge the battery. |
Reset to Defaults | You can only apply Load Factory, Save as Custom, or Load Custom if both the | |
|
| charger and the inverter are disabled. The display panel should respond with OK. |
|
| If Error appears, disable invert and charge and try again. |
Load Factory | If you select Load Factory, all PROsine settings will be reset to their default | |
|
| values. |
Save Custom | If you want to change the settings temporarily, you may want to save your current | |
|
| system settings. To save the current configuration of the PROsine, select Save |
|
| Custom. You can then restore this configuration to the PROsine at a later time. |
Load Custom | Select Load Custom to restore your custom settings to overwrite the current | |
|
| PROsine settings. |