Xantrex Technology PROsine 2.0 CHARGER Switch, CHARGER LEDs, Switch Position, Description

Display Panel Features

CHARGER Switch

This switch is active in all Display modes: ON, OFF, CONFIGURE.

Switch Position	Description
ENABLE	The charger is enabled and will charge the battery according to
	the way the unit is configured if shorepower is “good.”
DISABLE	The charger is off and will consume minimal power.

CHARGER LEDs

The LEDs are continuously updated whenever the Display Mode switch is set to ON or CONFIGURE.

LED	Description
	STANDBY	CHARGING
STANDBY	LED Status	LED Status
	OFF	OFF	The charger is not running because it is not enabled, the charge
and			cycle has been completed, or a system error has occurred.
	OFF	ON	The charger is running.
CHARGING	ON	OFF	The charger is enabled but is not running because shorepower
			is not “good.”
EQUALIZE	OFF		Equalize mode has not been selected.
	ON		The charger is in Equalize mode and the batteries are charging.
			CAUTION: Battery voltage may go up to 17V.
	FLASHING		Equalize mode has been selected; the charger is presently
			executing the basic charge cycle in preparation for
			Equalization mode. (The CHARGING LED is also on in this
			stage.)
READY	OFF		The charger is not running, or the Charge cycle is not finished.
	ON		The Charge cycle is complete. The battery is fully charged.

445-0089-01-01 2–9