Xantrex Technology PROsine 2.0 Connecting the AC Input Wires, General AC Wiring Considerations

Step 4: Connecting the AC Input Wires

Step 4: Connecting the AC Input Wires

WARNING: Fire, Shock and Energy hazards

Make sure wiring is disconnected from all electrical sources before handling. All wiring must be done in accordance with local and national electrical wiring codes. Do not connect the output terminals of the PROsine to any incoming AC source.

General AC Wiring Considerations

AC Wiring	Connect AC wires with twist-on wire nuts or crimp-on splice connectors
Connectors	according to the type of installation:
	• On a boat, use crimp-on splice connectors to meet the American Boat and
	Yacht Council’s Standards and Recommended Practices for Small Craft,
	which do not allow twist-on connectors for AC connections.
	• For non-marine installations subject to vibration, you should still use crimp-
	on connectors.
	• For non-marine installations in locations not subject to vibration, twist-on
	wire nuts may be used instead of crimp-on connectors.
	• The amount of insulation you strip off individual wires will be specified by
	the connector manufacturer and is different for different types of connectors.
AC and DC Wiring	Do not mix AC and DC wiring in the same conduit or panel. Where DC and AC
Separation	wires must cross, make sure they do so at 90° to one another. Consult code for
	details about DC and AC wiring in vicinity to each other.
AC Wiring	For your reference, the AC Wiring Compartment is shown in Figure 3-3.
Compartment

Figure 3-3Interior of AC Wiring Compartment

445-0089-01-01 3–11