Xantrex Technology PROsine 2.0 Part 1 General Configuration Information, Entering Configure Mode

Configuration

Part 1: General Configuration Information

All changes to the operation of the PROsine are made via the display panel. The unit must be in Configure mode or Installer-Only mode before you can change system settings. It is essential that you understand the implications of changing User and Installer settings. Be sure to study Chapter 3, “Installation” before you configure your system. Procedures for changing modes and values are given below.

Entering Configure Mode

To enter Configure mode:

•Set the DISPLAY switch to CONFIGURE.

This gives you access to all user-configurable items.

Entering Installer-Only Mode

WARNING: Fire hazard

The following information is for qualified installation/service personnel only. Incorrect configuration can lead to battery damage and risk of fire.

If a parameter is “Installer-Only,” it is meant to be configured by a professional installer who is not only familiar with the system settings on the inverter but also the ramifications of changing those settings. Setting these parameters incorrectly could damage connected equipment (e.g. batteries) or could severely affect the performance of your system. You will not be able to change parameters that are Installer-Only unless you place the display panel in Installer-Only mode.

If you try to change settings on a screen that contains installer-only data and the panel is not in Installer mode, this message appears for one second:

To Change; Enter Installer Mode

To enter Installer-Only mode:

•While the unit is in Configure mode, hold down the ESCAPE and DATA Down t buttons for 3–4 seconds.

A message cautions you that the panel is now in Installer mode and explains how to exit Installer mode.

The next time you press a key, a message appears to remind you that the panel is still in Installer mode.

Exit Installer-Only mode before you put the PROsine into service.

4–2 445-0089-01-01