Using your P80 power amplifier
P80 POWER AMPLIFIER
| SP1 | SP2 |
| POWER |
1 2
English
POWER (and power indicator light) 2
Switches the unit on and off. The light indicates the status of the amplifier.
When you switch your amplifier on, the light glows amber for a few seconds, during which time the speakers are disconnected. The light changes to green when the amplifier is ready for use. A red light means the amplifier is in standby mode.
The light may flash if a fault has occurred somewhere in the system (the fault type is shown on the front panel display of the A80). You should unplug the amplifier and leave it for a few minutes before reconnecting. If the fault cannot be cleared, unplug your amplifier and contact your Arcam dealer.
SP1 and SP2 1
These buttons allow you to select and deselect the main
(SP1) and secondary (SP2) sets of speakers attached to your amplifier.
NOTE: If both lights are out the amplifier will appear not to work, as all speakers are switched off. If both are on, overloads are more likely if low impedance speakers are connected.
A80/P80
11
