Setting up your A80 amplifier
The A80 allows you to adjust listening settings to suit your taste, and to customise various features of the amplifier to fit your system. Use this diagram to help you navigate through the settings available.
The ENTER and SELECT buttons are represented in the diagram
by the symbols 
and 
respectively. The Control knob is
shown as 
.
Adjusting listening settings
The default display mode is VOLUME, where the Control knob is used to adjust sound level.
Press SELECT to enter edit mode and cycle through the other settings: BALANCE, VOL RES, I/P trims, etc. When a setting is selected, press SELECT again and adjust it with the control knob. Press ENTER to fix the change you have made and return to idle (volume) mode.
Menu map
ARCAM A80 (‘Switch on’ state)
0 ... 72(dB)
volume
Adjust
L R
BALANCE
Adjust Balance
RES REF
RES FINE
RES STD
vol res
Adjust | Vol Res |
CD TRM 0
i/p trims
Adjust | I/P Trims |
PROC AV
FIXED 1...
Balance – Once selected, use the Control knob to shift the balance between Left and Right channels.
Volume Resolution – RES REF, RES FINE or RES STD. ‘Fine’ and ‘Standard’ represent different levels of volume control sensitivity. The ‘Reference’ setting gives absolute increments in 0.5dB steps.
Input Trims – use the source select buttons and Control knob to set input trims for each source. Input trims are used to compensate for variations in output levels of different source equipment.
proc mode
rec output
max on vol
Adjust | Proc Mode |
AV, PHONO, CD,
TUNER, AUX, DVD
Adjust | Rec Output |
|
ONVOL OFF
ONVOL 1...
Adjust | Max On Vol |
|
NO RESET
YES RESET
Processor Mode – This mode enables you to adjust the gain of the amplifier. The amplifier can then be used to drive the front left and right speakers in a surround sound system when fed from a separate processor. You can then control the volume of the entire system using the processor, feeding the sound into the TAPE input. Set the gain to match the amplifiers that drive your other loudspeakers.
Recording Output – This allows you to select the source signal for recording: AV, PHONO, CD, TUNER, AUX or DVD.
Maximum ‘On’ Volume – Use the Control knob to adjust the volume setting at
A80/P80
8
reset
|
|
|
| Reset – this restores all amplifier settings, including input trims, |
| Adjust | Reset | ||
| ||||
| to their factory defaults. | |||
|
| |||
|
|
|
| |
