Service information
Before returning your amplifier for service, please check the following:
Sound cuts out for no reason
If the temperature of the internal heatsink rises above a safe level, then a thermal cutout inside the amplifier will operate.
The power indicator on the front panel flashes and the protection system temporarily removes the power to the speakers. The system resets after the heatsink has cooled down.
Note that because of the high output voltage from a CD player, it is possible to drive the A80 at full power even though the volume is not set at maximum.
Amplifier does not switch back on
The A80 and P80 amplifiers have a protection mechanism which is activated if you switch the unit on immediately after turning it off. If this mechanism activates, wait 30 seconds then switch back on again.
English
Technical specifications
A80
P80
Continuous power output, per channel
Both channels, 8Ω, | 65W | 65W |
Single channel, 4Ω, 1kHz | 105W | 105W |
Distortion, 8Ω, 80% power, 1kHz | 0.005% | 0.005% |
Inputs |
|
|
Phono cartridge input sensitivity, MM | 2.5mV |
|
Line and tape inputs: |
|
|
Nominal sensitivity | 250mV | 700mV |
Input impedance | 22kΩ | 22kΩ |
Signal/noise ratio (CCIR) | 98dB | 108dB |
Preamplifier outputs |
|
|
Nominal output level
Output impedance
General
700mV
<50Ω
Power consumption (maximum) | 650VA | 650VA |
Dimensions W x D x H (including feet) | 430 x 330 x 75mm | 430 x 330 x 75mm |
Weight (net) | 9kg | 9kg |
Weight (packed) | 10kg | 10kg |
Supplied accessories | mains lead | mains lead |
|
| |
| 2 x AAA batteries |
|
E&OE |
|
|
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice.
NOTE: All specification values are typical unless otherwise stated.
A80/P80
13