McIntosh XR27 owner manual Screws for possible Future use

Figure 17

Remove this Screw

Figure 16

Opening for screw, allow- ing horizontal rotation of Column

Opening for screw, allowing close to wall mounting

Opening for Locking Screw

Top and Bottom L Mounting Bracket

down. When the desired angle is achieved tighten the four screws.

6.Locate the Loudspeaker Grille and align the fastening pins to the Grommets (there are four pins on each side) on the front of the XR27. Carefully push down to se- cure the Grille to the Loudspeaker until it is firmly seated.

Vertical On-Wall Installation

The supplied On-Wall Mounting Brackets allow for two different mounting positions of the XR27 Loudspeaker relative to the wall. The first position is with the Loud- speaker close to and parallel with the wall. The second po- sition places the Loudspeaker further away from the wall and allows for horizontal rotation of ± 30 Degrees.

1. Remove the four screws securing the Stabilizer Bar to

Stabilizer Bar Screws

Stabilizer Bar

Figure 14

the back of the XR27 Loudspeaker System. Refer to figure 14.

Note: Save the just removed Stabilizer Bar and screws for possible future use.

2. Using the supplied Allen Wrench and hardware, install four Allen Head 10/32 - 3/4 inch Screws into the open- ings vacated by the removal of the Stabilizer Bar.

3. Decide on which mounting position will be used for the Loudspeaker and re-

move one of the center
screws from both ends of
the Loudspeaker. Refer to
figure 15.
Note: Save the just removed
screws for possible	Figure 15
future use.

4.Attach the Nylon Pivot Pin to one of the L Mounting Brackets using the short Pivot Pin Screw and Lock Washer. Refer to figures 16 and 17 for the correct opening location.

5.Attach the other L Mounting Bracket to the Top of the Loudspeaker using the long Pivot Screw and Steel Bushing into the correct opening, based on the desired mounting position.

6.Determine the Loudspeaker Mounting Location on the wall, making sure that the Mounting Brackets will be

anchored to the studs located in- side the wall.

7. Referring to fig- ures 16 and 17 in- stall the Mounting Sleeve on the wall (orient with open- ing at the top) us- ing the supplied

Mounting Screws (Phillips Head 1/4 x 1-3/4 inch).

8. Referring to

figure 17, measure down from the just

mounted L Bracket and

install the Bot- tom L Bracket together with the Shim

Plate, using the supplied

Mounting Screws

(Phillips Head

1/4 x 1-3/4 inch).

9. With two per- sons, orient

the Loud- speaker End with the Top L Bracket above

the Mounting Sleeve and carefully line up the bracket

with the sleeve. Lower

the Loud-

speaker onto the Nylon Pivot Point on the Bottom L Bracket while at the same time the Top L Bracket is inserted into the Mounting Sleeve.

10.Install the Locking Screw together with the Flat Washer into the opening on the Top L Bracket to se- cure the Loudspeaker.

11.Locate the Loudspeaker Grille and align the fastening pins to the Grommets on the front of the XR27 (there

8