Meco Bonza Deluxe Series Manual Lighting of the Grill, How to manually light your LP gas grill

Manual Lighting of the Grill

·Open Hood before lighting the grill to prevent an explosion from gas build-up.

· Always inspect the gas hose and regulator as- sembly before each use. If the hose is cut, dam-

aged, or showing signs of excessive abrasion or wear, do not use the LP gas grill. Contact the manufacturer, as the hose must be replaced with an assembly specified by the manufacturer prior to further use of the LP gas grill.

4)Locate the control knob that corresponds to the match lighting hole that you are using. Push in and turn the control knob counter-clockwise until a click is heard.

WARNING: If the burner fails to ignite after following the above procedure, turn all the knobs

to

the off position and close the valve on the LP cylinder.

Wait five minutes and repeat all of the above manual lighting procedures. If the grill still fails

to light, see the Troubleshooting page.

5)Light the remaining burners from left to right by turn- ing the control knob counter-clockwise. Your grill has a crossover ignition system that allows the burners to light successively off one another. Confirm each burner is lit before lighting another burner.

How to manually light your LP gas grill

1)Open Hood.

2)Important: The LP gas cylinder valve must

be	opened first before turning the control knobs on
the	grill. Turn the handle on the LP cylinder valve

counter- clockwise until it stops.

3) Insert a lit match through one of the match-

lighting	holes underneath the front control panel on
the grill.	(See figure below).

1. Open hood

6)After ignition, burners should be burned at the high position for 3-5 minutes in order to preheat the grill. This process should be done before every cooking session.

The hood should be closed during preheating when cooking with gas. The hood should be open during preburn when using charcoal or wood chunks.

WARNING: If a burner goes out during the cooking cycle, turn all knobs to the off position and close the valve on the LP cylinder. Open hood and wait

2.Turn LP cylinder handle counter-clockwise - “ON”

3.Match lighting hole in left side of grill body - Insert a lit match through the match lighting hole.

4.Push in and turn control

knob counter-clockwise to the “High” position. (Note a click may be heard)

27