![](/images/new-backgrounds/1229423/22942345x1.webp)
·Never connect or disconnect LP gas cylinder or fittings while grill is in use or is hot.
·When the LP gas cylinder is connected, the grill must be kept outside in a
·Move gas hose as far away as possible from hot surfaces.
How to Connect your LP gas cylinder (See STEP 12 of Assembly Instructions for diagram)
1)Make sure all of the control panel knobs are turned to the “off” position and verify that the LP gas cylinder valve is closed by turning the handle on the LP gas cylinder valve clockwise until it stops.
2)Remove the protective cap from the LP cylinder gas nozzle.
3)Hold regulator in a straight line with LP cylinder gas nozzle so the connection does not cross thread.
4)Insert nipple into the LP cylinder nozzle opening.
5)Hand tighten coupling nut in a clockwise direction. Do not use tools.
6)Perform a Leak Test. (See STEP 13 of Assembly Instructions for Leak Test Instructions)
How to Disconnect your LP gas cylinder
1)Turn all control knobs to the “off” position and turn the handle on the LP gas cylinder clockwise until it stops.
2)Turn coupling nut on regulator in a
3)Place the protective cap over LP cylinder gas nozzle.
BEFORE USING YOUR
LP GAS GRILL
Selecting a Location
·Do not use an LP gas grill indoors, on recreational vehicles, or on a boat.
·This LP gas grill is for outdoor use only and should be placed on firm, level surface. The grill should be setup in an open area with good ventilation, away from high traffic areas and combustible materials.
·Combustible or flammable materials should never be used or stored within 36 inches of the back or sides of your LP gas grill.
·Locate your LP gas grill at least 10 feet away from your house or any building. Do not use the grill in a garage, breezeway, carport, porch, or under a surface that can catch fire.
·When moving or lifting your Aussie LP gas grill, its recommended that you grasp the cross supports under the side tables. Do not lift the grill with only the individual side table slats.
·When moving your gas grill, you should push the grill in front of you with the large wheels in the front.
Precautions
· Carefully read the Important Safeguards
section | of this manual (pages 2 thru 4). Make |
sure you | follow and understand all instructions |
and |
|
warnings. If you have any questions | |
regarding | these pages, call |
· This installation must conform with local codes or, in the absence of local codes, with either the
National | Fuel Gas Code, ANSI Z223.1, or CAN/CGA- |
B149.2, | Propane Installation Code. |
·If an external electrical source is utilized, the outdoor cooking appliance, when installed, must be
electrically grounded in accordance with local
codes or, in the absence of local codes, with the
National | Electrical Codes, ANSI/NFPA 70, or the | |
Canadian | Electrical Code, CSA C22.1. | |
· If any electric appliance or rotisserie is used with | ||
the | LP gas grill, do not allow cords to touch or be near | |
hot |
|
|
surfaces. Electric cords should be placed away from walkways to avoid a tripping hazard.
· Grill storage cover must be removed and placed
at least 36 inches from the LP gas grill while in use.
The | grill cover is made of a flammable material. The | |
grill | must be completely cooled before putting the | |
cover back on the grill. | ||
· Never store a spare or disconnected LP gas | ||
cylinder | under or near this LP gas grill. | |
· Inspect the hose and regulator assembly before | ||
each | use. If the hose is cut or damaged or shows | |
signs of | excessive abrasion or wear, do not use the | |
LP gas | grill. Contact the manufacturer, as the hose | |
must be | replaced with an assembly specified by the | |
manufacturer prior to the further use of the LP | ||
gas | grill. | |
· Use only the hose and regulator assembly that | ||
is | supplied with your LP gas grill. | |
· Use of this LP gas grill other than for the | ||
intended | use, or alteration of the LP gas grill in any | |
way may | not be safe and will void any warranty. |
·LP gas is not natural gas. The conversion or attempted use of natural gas in an LP unit is dangerous and will void your warranty.
·Never use an LP gas cylinder if it shows signs of: dents, gouges, bulges, fire damage,
corrosion, | leak age, excessive rust, or other forms of | |
visual | external damage; it may be hazardous and | |
should be | checked by a Liquefied Petroleum supplier. | |
Do not | use an LP cylinder with a damaged valve. |
23