Setup Codes for Cable Converters, Abc, Nsc

PROGRAMMING CABLE CONVERTER OR SATELLITE RECEIVER CONTROL

Locate the brand name of your Cable Converter or Satellite Receiver in the Setup Codes For Cable Converters or Setup Codes For Satellite Receivers section starting below, and write it in the appropriate space.

Cable Converter Brand: ________________________

Satellite Receiver Brand:________________________

The brands are listed in alphabetical order with the most popu- lar codes listed first.You will use one of these codes to program the One ForAll 4-DeviceVideo Expert Plus With Learning remote control to operate your Cable Converter or Satellite Receiver.

1.Turn on the Cable Converter or Satellite Receiver.

2. On the remote control, press CBL/SAT once. Press and hold SET until the LED blinks twice, then release SET.

3.Enter the first four-digit code for your Cable Converter or Satellite Receiver. If performed correctly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the remote control at your Cable Converter or Satellite Receiver and press POWER once.The unit should turn off.If it does not respond,repeat steps 2-3,trying each code listed for your brand until you find one that works.If it still does not work , try searching for the code (see page 23).

5.Write your Cable Converter or Satellite Receiver code in the boxes below for future reference.

NOTE: Remember, to use the One For All 4-Device Video Expert Plus With Learning remote control to operate your Cable Converter or Satellite Receiver, press CBL/SAT first.