Mercury 8 Reset Button Bank button and any PC button, Below are the different hot key commands

Mercury 8/16 User’s Manual

Reset Button ( (“Bank” button) and (“any PC” button)):

To press both “PC1” button and “bank” button of master bank simultaneously can reset KVM switch. This reset action will not only return KVM switch back to initial state --- Check the password, but also re-check all of slave banks which connected to mast KVM Switch. If you add a new KVM Switch as a slave bank, please use reset button of master KVM Switch to automatically assign a new ID to it. You can view this new slave bank go through OSD menu. The PC ports of KVM Switch do not be reset by reset command.

Keyboard Hot Key Commands:

You can also conveniently command KVM switch by switching port s through simple key sequences. To send commands to KVM switch, the “SCROLL LOCK” key must be pressed twice within 2 seconds. You will hear a beep for confirmation and the keyboard is in hot key mode. If you have not pressed any key in hot key mode within 2 seconds (It means to key in any key follows up “Scroll Lock” “Scroll Lock” key ), the keyboard will back to under Operation System control state.

Below are the different hot key commands:

Within 2second

Scroll	Scroll		↑
Lock	+ Lock	+		=	Previous Channel

Scroll	+	Scroll	+	↓	=
Lock		Lock				Next Channel
						(Note: You also could press “up
						arrow key” or “down arrow key”
						longer time to speed up selecting
						the destination port)
Scroll	+	Scroll	+	Page		= Previous Bank
Lock		Lock		Up

10