Xerox 4213 Mode change command, PostScript Emulation, HP PCL Emulation, XES Emulation, Reset

XES COMMAND LANGUAGE MODE

The mode change command

The mode change command resets your 4213, enabling it to accept printing commands in the desired emulation mode.

Note: Unpredictable results such as loss of data may occur if the mode change command is not entered with valid parameters.

Send the following commands to your printer, preferably in the form of a test file:

PostScript Emulation =MCK=EMULATE/POSTSCRIPT/END L

This information tells your printer to begin printing in the

PostScript emulation mode.

HP PCL Emulation =MCK=EMULATE/PCL/END L

This information tells your printer to begin printing in the HP PCL emulation mode.

XES Emulation =MCK=EMULATE/XDCS/END L

This information tells your printer to begin printing in the XES emulation mode. You can replace ªXDCSº with either ªXESº or ª2700º in the mode change command to enter the XES emulation mode.

Note: A space is required immediately after the =MCK= sequence. A line ending following the END keyword completes the command.

The reset command

The reset command resets the 4213 laser printer, restoring it to the default settings that were in effect at the last power off cycle.

Send the following command to your printer, preferably in the form of a text file:

Reset =MCK=RESET/END L

2-2 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE