Xerox 4213 manual Tn1,n2,...,n160 L

XES COMMAND LANGUAGE MODE

Syntax Etn1,n2,...,n160L

t

n1,n2,..,n160

Instruction to set horizontal tabs.

Tab settings across the page starting from the left edge. Up to 160 tabs can be set in one command. Commas separate values. See table 2-4 for default horizontal tab values for portrait and landscape pages.

LLine end.

Where to place it At the start of the job or anywhere a horizontal tab is desired.

Example Figures 2-7 and 2-8 show a line of tabs across an 216 by 279 mm portrait page. Figure 2-7 shows the settings in units of five pixels (1/60 inches). Figure 2-8 shows the same settings in units of one pixel (1/300 inches).

More Up to 160 horizontal tabs may be set per job. If you try to set more, the printer will consider all tabs to the right of the last tab setting as spaces. This will affect the appearance of the page.

Table 2-4.Default values for horizontal tabs

	U.S.	U.S.	International	International
Position	portrait	landscape	portrait	landscape
1st tab	1.1 inch	1.1 inch	1.04 inch	1.04 inch
	28 mm	28 mm	26.4 mm	26.4 mm
	330 dots	330 dots	313 dots	313 dots
Intervals	0.44 inch	0.44 inches	0.48 inches	0.48 inches
	11.2 mm	11.2 mm	12.2 mm	12.2 mm
	132dots	132 dots	144 dots	144 dots

2-46 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE