Xerox 4213 manual Load Translation Table, Syntax Ezt

		XES COMMAND LANGUAGE MODE
Where to place it	At the start of the job.
Example	To move the % symbol from its current hex location of 25H to a
	new location at 7EH, enter:
	E+T,L
	ES40500FC2500FFXL
	The data record in this example is summarised below.
	S	A data record always begins with the letter ªSº.
	4	4 is used here. The use of other numbers excludes
		certain fonts.
	05	Use 05 as the byte count to move one character at
		a time.
	00FC2500	The data following the byte count consists of the
		the hex values of the character or characters being
		assigned.
	FF	Always put FF at the end of each record. To move
		more characters, make additional records.
	XL	X and L together terminate table loading and
		should be included after the FF in the last record.
More	The Reset command returns the printer to the default language.

Load Translation Table

Purpose Loads a special translation table for Laserpage software. This command performs the same function as the E+T command, but does not cause a page eject.

Syntax

Ezt

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-113