Xerox 4213 manual Origin and page orientation, Placement on

XES COMMAND LANGUAGE MODE

If a graphic window has been stored in the printer's memory, it remains until you power off the printer, switch emulations, or perform a reset.

Note: If the printer receives graphic data that is incomplete, e.g. the data has fewer bytes than the window size, the next Form Feed command may be ignored, causing unpredictable results.

Origin and page orientation

The graphic window's origin is always the corner of the window closest to the upper left hand corner of the page. It is independent of page origin, feed direction, or paper size. (See figure 2-19).

Since window boundaries cannot be seen on your host computer screen, you may want to sketch an outline of the window on paper, then enter the commands based on the measurements in your sketch.

Figure 2-19.Graphic windows for portrait and landscape printing

Placement on the page

You can define a window so that part of it is located either above the top of the page or below the bottom of the page. If you place an entire window off the page, nothing is printed and an error message appears on the XES Summary Sheet.

You can place windows and copied windows on top of each other on the page. However, this type of page complexity may slow the processing speed of the printer.

2-80 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE