Xerox 4213 manual Current textErl75eNew text

XES COMMAND LANGUAGE MODE

Syntax ErDnc

	r	The instruction for relative placement
	D	A	character indicating the direction from the current
		text position in which the text is to be placed:
		u	Up
		d	Down
		l	Left
		r	Right
	n	The distance in pixels (or 1/300th inch) from		the
		current text position to the new text position.
	c	Any non-numeric character can be used to complete
		this command.
	Note: This is one of a few commands using a printable character
	rather than a line end for completion. Do not use a line end.
Where to place it	Immediately		after the current text (that is, the text being used	as
	a point of reference) and immediately before the text to be
	affected.
More	For both landscape and portrait pages, it is possible to print text
	off the left edge of the page. For example, entering Erl3000b will
	not cause an error. However, any text after the command and
	before a line end will print off the page.
Example	To place text 75 pixels to the left of the current position, enter
	(Current text)Erl75e(New text)

As shown in figure 2-13, the final word of a sentence is placed 1500 pixels down from the current text position.

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-61