Xerox 4213 manual Font Select, Setting units of measure

XES COMMAND LANGUAGE MODE

Font Select

Purpose

Syntax

Selects a font from those listed in the index created with Font ID Assignment.

En

nThe ID number for the font, from 0 to 9.

Where to place it Anywhere in the document at which you want to use this font.

Example From the following index:

E+0Classic8iso-LL

E+1Classic8Biso-LL

E+2Classic6iso-LL

E+3Classic12iso-LL

E+4Classic10iso-LL

to select Classic8Biso-L within a document, enter:

E1

More If you specify a number that is not assigned first with a Font ID

Assignment, the printer continues printing with the current font.

An error message appears on the Summary Sheet.

To select the default landscape font (without having assigned a font ID), use E0.

To select the default portrait Titan font (without having assigned a font ID), use E1.

You may want to select either the default portrait or landscape font to identify the page orientation. The first font called out determines the orientation of the page.

Setting units of measure

Margins and tabs are set either in units of five pixels (1/60 inches) or in units of one pixel (1/300 inches). You select the unit of measure by entering UnitsÐ1/60th or UnitsÐ1/300th. The Units commands are entered before those for margins or tabs settings. They need not be entered immediately before, however. You do not need to enter a Units command more than once in a job.

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-37