XES COMMAND LANGUAGE MODE

The command remains in effect until either a Reset command or another Paper Tray command is received. Thus, it is possible to change paper trays within a document as many times as you wish.

If more than one Paper Tray command is entered on a page, the printer recognises only the last one.

Notes: If Tray sequence mode is enabled, the same size paper trays, the same paper size, and the same paper type should be installed in the selected trays.

The factory default tray selection is trays 1 and 2.

Bypass Slot Paper Size

Purpose

Syntax

Where to place it

Indicates the paper size being fed through the bypass slot.

Ezybn

zyb Instruction for paper size being manually fed.

nIndicates paper size selection

At the start of the page, before any text prints, and after the Paper Tray selection command (Ec9). If this command is entered after any printable data, it takes effect on the next page.

Example To print from the bypass tray on letter-size paper, enter:

Ec9Ezyb0

Notes: This command accommodates paper sizes that will not print on the 4213. The user may get incorrect printed output that is formatted for the page size, but is not printed on that page size. The maximum paper width and length that can be used on the 4213 are 257 mm x 364 mm. The minimum length is 190 mm.

Specifying an n value smaller than the minimum length, such as n=6 (A6, 105 x 148 mm), or n=C [Postcard, (89 mm x 140 mm) (3.5º x 5.5º)] will cause the printer to jam.

2±22

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE

Page 60
Image 60
Xerox 4213 manual Bypass Slot Paper Size, Ezybn