Xerox 4213 manual Additional pairs of starting and ending angle

XES COMMAND LANGUAGE MODE

rThe radius of the arc.

S1	The starting point of the arc, expressed in degrees
	on a circle. The printer draws in a
	counterclockwise direction.
E1	The ending point of the arc, expressed in degrees.
Sn,En	Additional pairs of starting and ending angle
	degrees, as many as desired. If either point is
	missing from the pair, the other is ignored and an
	error message appears on the Summary Sheet. The
	starting degree cannot be the same as the ending
	degree. Degrees must be positive, whole numbers.

LLine end.

Figure 2-28. Arcs

More If the degree of either the starting angle Sn or the ending angle En is missing, the printer ignores the command. If neither a starting nor an ending degree is indicated, the printer draws a complete circle.

2-96 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE