XES COMMAND LANGUAGE MODE

When the printer is powered on, units of measure are set at 1/60th inches automatically. The Reset command, which clears all settings, also returns the units to 1/60 inches. Thus, at the start of a job, if you want to use 1/60 inch for your unit of measure, you need not use the Units command.

If your job requires calculations for absolute or relative placement of text, or for nongraphic lines, all of which are measured in units of one pixel or 1/300 inch, you may want to select UnitsÐ1/300 for margins and tabs as well.

Appendix B, ªConversion tables for units of measure,ª lists 1/60 and 1/300 inch equivalents for inches, millimetres, 10-pitch characters, and 12-pitch characters.

UnitsÐ1/60

Purpose Sets five pixels (1/60 inch or .42 millimetres) as the unit of measure for margins and tabs.

Syntax

Ezg

 

Where to place it Before the margins or tabs command to which it applies.

UnitsÐ1/300

Purpose

Syntax

Where to place it

Sets one pixel (1/300 inch or .08 millimetres) as the unit of measure for margins and tabs.

Ezf

Before the margins or tabs command to which it applies.

2-38

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE

Page 76
Image 76
Xerox 4213 manual UnitsÐ1/60, UnitsÐ1/300, Syntax Ezg, Ezf