Xerox 4213 manual Perforation Region, Purpose

LJ SERIES 2D EMULATION

The text length is set to the user default whenever the page orientation, length, size, or top margin is changed. The user default is calculated as the quotient (integer) of the following equation:

(Printable Area Length-TopMargin- )48 ÷ VMI

where Printable Area Length and Top Margin are measured in inches.

Syntax E &l#F

where # is the number of lines of text required.

Example To set a text length of 55 lines, enter:

E&l55F

Hex	1B 26 6C 35 35 46
Dec	27 38 108 53 53 70

Perforation Region

Purpose	The Perforation Region command determines the action of the
	printer when text is positioned below the bottom line of text
	defined by the Text Length command. When the Perforation
	Region is enabled, text which would fall below the bottom line
	specified by the Text Length command is moved automatically to
	the top of the text area on the next page.
	When		Perforation Region is not enabled, text may extend
	beyond the bottom of the text area and may not be printed if it
	continues out of the printable area. The default setting is
	Perforation Region enabled. The size of the perforation region
	depends on the dimensions specified by the Page Size and Page
	Length		commands.
Syntax
		E &l#L
	where		# = 0 disables Perforation Region
			# = 1 enables Perforation Region.

3-24 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE