Xerox 4213 manual Font ID Assignment, +nfontnameL

XES COMMAND LANGUAGE MODE

The most common place to enter Font ID Assignment is immediately after Print Job and any job formatting commands (such as Paper Tray). However, you can set up an index anywhere in the document. The advantage of this is that, while you can index up to 10 fonts (using 10 different font ID numbers) with a single Font ID Assignment, more than 10 may be used by repeatedly creating new indexes throughout the document.

The number of fonts that can be used on a page is limited only by the memory capacity of the printer.

Up to 512 fonts (including cartridge fonts) can be present at the same time, provided the downloaded fonts do not exceed the available memory of the printer. Because there are four resident fonts, 508 is the maximum number of fonts the user can download.

Note: The 4213 may require up to 10% more internal storage for existing XES fonts from previous XES printers.

Font ID Assignment

Purpose Sets up a numbered index of up to 10 fonts stored on the printer. These fonts can then be selected by their ID numbers in the document.

Syntax

E+nfontnameL

+nThe instruction to assign an ID number, with n being the number from 0 to 9.

fontname The name of the font to correspond to this number.

LLine end.

Where to place it After the Print Job command and the Paper Tray command, or any point in the document where you want to select fonts.

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-35