28
Appendix B
Default Settings
The scanner is shipped from the factory programmed to a set of default
conditions. The default parameter of the scanner has an asterisk ( * ) in the
charts on the following pages. If an asterisk is not in the default column then
the default setting is Off or Disabled.
Every communication does not support every parameter. If the communica-
tion supports a parameter listed in the charts on the following pages, a check
mark will appear.
For the scanner to communicate with your host system properly, program it to
meet the specific scanning needs. Since each host system is unique, change the
default settings to match the host system requirements. For information on how
to change the default settings, refer to the Configuration of the Scanner to the
Host System section or the ScanSelect™ Scanner Programming Guide.
Parameter Default OCIA IBM Key RS- Parallel Light
46XX Wedge 232* Pen
UPC/EAN *T T T T T T
Code 128 *T T T T T
Code 93 *T T T T T
Codabar *T T T T T
Interleaved 2 of 5 *T T T T T
(ITF)
MOD 10 Check T T T T T
on ITF
Code 11 T T T T T
Code 39 *T T T T T
Full ASCII T T T T T
Code 39
MOD 43 Check T T T T T
on Code 39
MSI Plessey T T T T T