Metrologic Instruments MS9530 Series manual Fixing Voyager RF ID Numbers

FIXING VOYAGER RF ID NUMBERS

This section explains how to fix an Identifier number to each Voyager RF. Basically, each Base Station can work with up to 5 VoyagerRF’s at the same time. To enable this facility, an Identifier Number (ID) must be configured to each Voyager RF. By reading RF Defaults, ID=1 is configured.

There cannot be more than one Voyager RF with the same ID and Serial Number.

In the case of two Voyager RF’s trying to communicate with the base station at the same time, the unit with the lower ID will re-try first. That means that the lower a number ID the VoyagerRF has, the more aggressive it will be.

To change the ID, follow the steps below,

•Read desired Voyager ID:i (i=1,..,5) barcode to load the ID = i into the Voyager RF

MS9530 Voyager RF	9	Printed: September 2002
Version: 1.1		Status: Approved