• Read Fix Serial RF Number barcode to load Base Station's serial
number into the Voyager.
• Read Base Station Serial Number barcode. (located on the Base
Station).
• Read Enter/Exit Configuration Mode barcode.
• After reading this barcode the Voyager will try to link the
Base Station. Now a linking should be performed.
At this moment the Voyager RF is linked to Base Station with ID =1.
Two Voyager RF’s with the same ID cannot be linked to the same
Base Station. In this case, follow the “Changing ID procedures” to
change the ID of the appropriate Voyager RF
The user can change any parameter of MetroSelect’s Single Line Configuration
Guide apart from the following:
RS-232, Keyboard, OCIA, Light Pen Parameters, IBM 46xx Configuration,
Custom Defaults, Scanner Operation-Led Options, Scanner Operation-
Host Scanner Commands, Scanner Operation-Test Modes, MS 9500
Voyager-Activation Range, MS 9500 Voyager-CodeGate Status
Failure to observe the above will result in the scanner operating with reduced
functionality.
NOTE ABOUT RF DEFAULTS:
This barcode will default the RF parameters of Scanner:
• RF interface will be fixed
• Serial Number will be fixed to 9999999999
• ID number will be fixed to 1
• Minimum length will be fixed to 1
MS9530 Voyager RF Printed: September 2002
Version: 1.1 Status: Approved
8