Metz 30 TL 55, 30 LCD-TV PIP manual Programming the remote con- trol for the individual devices

3. The remote control

1.Programming the remote con- trol for the individual devices

In order to control your various devices with the remote control, you must first programme it with a three-digit number for each operating level.

•TV (TV set)

The TV operating level is programmed in the factory for the Metz 30 LCD-TV PIP. You cannot enter any other code.

•VCR 1 (video recorder 1) VCR 2 (video recorder 2) DVD player

HiFi (e.g. amplifier, tuner, tape, etc.) The remote control must be programm- ed with suitable codes from the code list.

☞Note the factory settings (page 6) and see the code list at the end of this manual.

1.1Entering the codes for VCR and DVD

☞After executing steps a) to c), you have about 15 seconds to make further entries. If you do not do so, the remote control returns automa- tically to the TV operating level.

a)Use the Select key to select the desired operating level. The coloured LED for the selected level lights.

b)Press and hold the keys and l–ll until the LED blinks twice.

c)Enter the appropriate code (see the code list) with the numeric keys.

If the code is accepted, the LED again blinks twice. If you enter a non-exi- stent code, the LED lights once for about two seconds.

1.2Entering the codes for CD player, tuner and tape

☞After executing steps a) to c), you have about 15 seconds to make further entries. If you do not do so, the remote control returns automa- tically to the TV operating level.

a)Use the Select key to select the opera- ting level HiFi. The coloured HiFi LED lights.

b)Press the key, release it and then press the key:

...l–ll for CD player,

... ￿ for tuner (radio) or

... for tape (cassette recorder)

on the remote control until the LED blinks once.

c)Enter the appropriate code (see the code list) with the numeric keys.

If the code is accepted, the LED again blinks twice. If you enter a non-exi- stent code, the LED lights once for about two seconds.

8