107
k
13. Wide-angle diffuserThe wide-angle diffuser can be used for light coverage as of 20 mm focal
length (35 mm format) or as of 50 mm focal length and more (6x6 format).
Set the reflector manually to 24 mm zoom position.
The guide number for use of the wide-angle diffuser is 30.
14. Manual flash exposure correcctionThe automatic exposure system of the mecablitz and most cameras is based
on a subject reflection factor of 25 % (average reflection of subjects shot with
flash). A dark background that absorbs a great deal of light, or a highly re-
flective bright background (e.g. when shooting against the light), can result in
overexposure or underexposure.
To compensate for the aforementioned effect, the exposure can be manually
corrected with a correction value adapted to the given photographic situa-
tion. This correction value depends on the contrast between subject and
background! In the TTL and A mode of the mecablitz, manual flash exposure
correction factors of -3 EV to +3 EV (f-stops) can be set in one-third incre-
ments. Many cameras have a setting element for exposure corrections which
can also be used in the TTL flash mode.
Please refer to the explanations in the operating instructions for the given
camera and the SCA adapter.
Exposure correction by changing the aperture on the lens is not possible in
this instance because the camera’s automatic exposure system will regard the
changed aperture as the normal working aperture.
Dark subject in front of a bright background: Positive correction value
(approx. 1 to 2 f-stops EV)
Bright subject in front of a dark background: Negative correction
value (approx. -1 to -2 f-stops EV)
The entering of a correction value may result in a change of the maximum
flash range indicated on the LC display of the mecablitz and its adaptation to
the correction value (depending upon the camera type and SCA adapter)!
☞
☞
Setting manual flash exposure correction:
• The mecablitz is operating in TTL flash mode or in A flash mode.
• Turn the setting disk until the „EV“ symbol appears on the LC display. The
arrow symbol alongside „EV“ indicates that a position has been reached
where you can enter a correction value.
• Press the setting disk in the direction of the arrow. The arrow symbol along-
side „EV“ starts to flash.
• Turn the setting disk to set a suitable correction value. The correction value
is shown on the LC display of the mecablitz.
• Press the setting disk in the direction of the arrow for storage. The selected
value is automatically stored after 5 seconds if the setting disk is not pressed.
The arrow symbol alongside „EV“ ceases to flash. The set value is displayed
on the LC display of the mecablitz.
Deactivating manual flash exposure correction:
• Turn the setting disk until the arrow symbol appears alongside „EV“ on the
LC display.
• Press the setting disk. The arrow symbol alongside „EV“ starts to flash.
• Turn the setting disk until the displayed correction value is extinguished on
the display.
• Press the setting disk in the direction of the arrow to confirm deactivation. If
the setting disk is not pressed the function is automatically deleted after
5 seconds. The arrow symbol alongside „EV“ ceases to flash.
Manual flash exposure correction is only possible if the camera sup-
ports this function! If the camera does not support this function, the
correction value can be adjusted on the mecablitz, but cannot become
effective!
Transmission of the correction value from the mecablitz to the camera is only
possible when an SCA 3xx2 adapter is used!
☞
703 47 0122-A3 70MZ-4-5 14.03.2006 13:40 Uhr Seite 107