4. Aerial Control Assigning LNC or polarizer values
Depending on the type of satellite aerial you use, there are three methods of aerial control for selection of H and V polarization:
•control by means of the LNC voltage (the most common method),
•control with the aid of a magnetic polarizer,
•control with a relay.
The appropriate control method for polarization must be selected in the station table. H for horizontal polarization or V for vertical polarization is displayed in the submenu „Aerial control“ of this table.
Press this key on the remote
control
1.Call the station table and select the submenu „Chan- nel“
The screen displays
3 | SAT 1 | 40 | Aerial | |
44 |
| Std channel |
|
|
45 |
| Spec. channel |
| |
46 |
|
| ||
|
|
| ||
47 |
|
|
| |
| H: 11,494 ARD | |||
48 | AV | |||
49 |
| Aerial control |
|
3 | SAT 1 | 40 | Aerial | |
44 |
| Std channel |
|
|
45 |
| Spec. channel |
| |
46 |
|
| ||
| Fine tuning |
|
| |
47 |
|
|
| |
48 | AV | H: 11,494 ARD | ||
49 |
| Aerial control |
| |
| >> weitere Einstellungen |
Explanation
The frequency setting may differ from model to model, as shown in the picture.
2.Call the submenu „Aerial control“ and set the LNC voltage
red
- | + |
|
3.Make the LNC selection (required only for multi-
switch systems)
- | + |
|
LNC pwr supply: | H |
22 kHz signal: | On/Off |
Polarizer: | 1 |
AV Relay: | On/Off |
AFC: | On/Off |
6 9 6 + S 0 4 B - G B |
|
store ? | |
| OK |
LNC pwr supply: | H |
22 kHz signal: | On/Off |
Polarizer: | 2 |
AV Relay: | On/Off |
AFC: | On/Off |
6 9 6 + S 0 4 C - G B |
|
| store ? |
| OK |
| 696ˇˇ S00 |
In this submenu, one of the previously set values (see sections 1 and 2 of these operating instructions) can be selected and assigned to the current SAT program position. This is done with the aid of the colored keys.
When you press the blue key, the text „LNC power supply“ is displayed on a blue background to indicate that it is active.
You can select the control voltage for either H or V
polarization with the | - | + | keys. |
|
|
The setting of the control voltages is described in sec- tion 2 of these operating instructions.
Here you can superimpose a 22 kHz switching signal upon the LNC voltage for horizontal or ver- tical polarization.
This is used to select the desired input of a multi- switch system.
10