Microboards Technology | Print Factory |
8)Push the print cartridge firmly into the cradle.
9)Secure the cradle latch.
Installing Disc Guide and Output Bin
•To install the output bin, lift the front end of the printer.
•Align the two holes in the output bin with the rubber feet on the front of the printer.
•Lower the front end of the printer.
•The output bin should now be securely in place.
•To install the disc guide, place the metal bracket, facing down, into the output slot of the printer.
•The metal bracket will hold the disc guide in place.
•Please make sure the disc guide is centered in the output slot.
•If it is not centered, it can prevent the discs from completely ejecting out of the printer.
Connecting to a Computer
You have two options when connecting to a computer, USB and Parallel. You will need to decide which method is available on your computer. Follow the instructions listed below.
Parallel Port
Confirm that your PC is turned off.
Plug the printer cable into the back of the printer. Use the locking clips to secure the connection.
Plug the other end of the cable into the parallel port on the back of the PC. Secure the connection by screwing in the two posts.
Proceed to “Installing the printer driver” to complete the installation.
USB Port
Confirm the PC is turned off.
Plug the small end of the USB cable into the back of the printer.
Install the larger end of the USB cable into an available USB port on the PC. Confirm that both ends are securely in place.
Proceed to “Installing the printer driver” to complete the installation.
7
